Week 12, April 30, 2019

This week we plan to finish our solidworks design for our claw bot. We also plan on finishing the actual build for the clawbot, however I have a good feeling we are going to be delayed again. We are gonna try to finish it as fast as possible.

Week 11, April 26, 2019

This week we started building our claw bot. we are still working on our design and are planning as we go to catch up with everyone else. Hopefully we don't run into any complications that could slow us down.

Week 11, April 22, 2019

This week we managed to complete 1 figure 8 autonomously. This means that we are able to get a
50% and move on. Hopefully we do not struggle with the tetrahedron challenge because we are very far behind.

Week 10, April 17, 2019

This week we got almost nothing done. If anything we went backwards. We had to restart our code because it was giving us too many problems. We are very far behind.

Week 10, April 15, 2019

This week our goal is to finish the Figure 8 Challenge and start building our claw bot. We are very far behind and we are struggling, however we can pull through.

Week 9, April 11, 2019

This week was a complete fail. We finally figured out that one of our gears were messed up so we had to replace it. Now we have to recode the entire robot again to fix our mistake.

Week 9, April 9, 2019

This week our goal is to start the tetrahedron challenge. We also need to figure out the problem with our robot before we move on.

Week 8, April 5, 2019

This week we still have not finished our autonomous Figure 8 Challenge yet. Our robot is slowly failing on us so we are working extra hard to fix it.

Week 8, April 1, 2019

this week our goal is to begin the tetrahedron challenge. We are a few steps away from finishing the Figure 8 and we plan on finishing it on Friday.